You should have fitted Air-Only ventilator (model DS)!
Find part images and part codes mentioned below in Specification
Threaded pin requires cutting to length prior to assembly.
Screw threaded pin into DS4 from the Breezy set and replace existing.
Refit o-ring.
Screw handle B2 to pin. Measure A as shown on Picture 1.
Unscrew pin and cut (Amm-50mm).
Fit DS4, pin and B2. You will get result as shown on Picture 2.
Trial fit B1 (Picture 3). Using B1 as template mark places for screws.
Remove it. Screw shelter B3 to ceiling as shown on Picture 4 and 5.
Check motor and on-board voltage.
Complete assembly by connecting electricity to the motor (Red wire [+], black wire [-]) and fitting B1 (Picture 6).
Example : fitting of Breezy and Air-Only Low Profile deck ventilator (model DSLP)
|
