Assembly

wooden electric assembly

  • You should have fitted Air-Only ventilator (model DS)!
  • On the picture above 35 mm is minimum required space for fitting wooden electric ventilator.
  • Threaded pin requires cutting to length prior to final assembly.
  • Screw threaded pin with wooden handle into DS4 from the set and replace existing. Refit o-ring.
  • Trial fit wooden ventilator. Measure threaded pin and cut it.
  • If necessary arrange walling between deck and selling using plywood, foam, rubber etc.
  • Check motor and on-board voltage.
  • Complete assembly by connecting electricity to the motor (Red wire [+], black wire [-]) and fitting the ventilator in place.